Alcatel-Lucent OmniSwitch 6250, Cli Reference Manual, Page: 78 / 2018

Chassis Management and Monitoring Commands
page 2-26 OmniSwitch 6250 CLI Reference Guide November 2009
stack set slot mode
Sets the switch to either stackable or standalone mode. The stack set slot mode command also provides
syntax for immediately rebooting the corresponding switch.
stack set slot slot-number mode {stackable | standalone} [reload]
Syntax Definitions
slot-number The current slot position used by the switch (1–8; 1001–1008). Note that
the valid slot number range also includes slot positions 1001 through
1008, reserved for switches in pass-through mode.
stackable Sets the switch to stackable mode allowing the switch to be stacked into
a virtual chassis using the fixed fiber ports.
standalone Sets the switch to standalone mode allowing the fixed fiber ports to be
used as uplink ports.
reload Optional command syntax. When reload is entered in the command
line, a confirmation prompt is issued. If the user approves the reload, the
corresponding switch will be rebooted immediately and the new
mode will take effect when the switch comes back up.
Defaults
Platforms Supported
OmniSwitch 6250-Metro Models
Usage Guidelines
•
The switch must be rebooted for the new mode to take affect.
Examples
-> stack set slot 2 mode stackable
Release History
Release 6.6.1; command was introduced.
parameter default
mode Standalone