Alcatel-Lucent OmniSwitch 6250, Cli Reference Manual, Page: 743 / 2018

Ethernet Port Commands
OmniSwitch 6250 CLI Reference Guide November 2009 page 20-71
show interfaces hybrid status
Displays interface line settings (e.g., speed, mode) for combo ports only.
show interfaces [slot[/port[-port2]]] hybrid {fiber |copper} status
Syntax Definitions
slot Slot number you want to display.
port Port number of the interface you want to display.
port2 Last port number in a range of ports you want to display.
fiber Specifies that the status of the SFP port(s) will be displayed.
copper Specifies that the status of the copper RJ-45 port(s) will be displayed.
Defaults
If a specific slot or slot/port number is not entered with this command, the status and configuration
configuration for all switch combo ports is displayed..
Platforms Supported
OmniSwitch 6250
Usage Guidelines
•
Use the slot , slot/port , or slot/port-port2 parameters to display the status and configuration for all ports
on a slot, a specific port, or a range of ports.
•
The hybrid mode for combo ports is not configurable; combo ports are set to preferred fiber by default.
As a result, the Hybrid Mode field always displays preferred fiber (
PF ) for all combo ports.
Examples
-> show interfaces hybrid fiber status
DETECTED CONFIGURED
Slot/ AutoNego Speed Duplex Hybrid Speed Duplex Hybrid Trap
Port (Mbps) Type (Mbps) Mode LinkUpDown
-----+--------+------+------+------+--------+------+------+------
1/25 Enable - - - 1000 Full PF -
1/26 Enable - - - 1000 Full PF -
FF - ForcedFiber PF - PreferredFiber F - Fiber
FC - ForcedCopper PC - PreferredCopper C - Copper
output definitions
Slot/Port Interface slot/port number.
AutoNego Autonegotiation status (Enable/Disable).
Detected Speed Detected line speed (10/100/Auto/1000/10000 Mbps).