Alcatel-Lucent OmniSwitch 6250, Cli Reference Manual, Page: 675 / 2018

Ethernet Port Commands
OmniSwitch 6250 CLI Reference Guide November 2009 page 20-3
trap port link
Enables trap link messages. If enabled, a message is displayed on the Network Management Station
(NMS) whenever the port changes state.
trap slot[/port[-port2]] port link {enable | disable | on | off}
Syntax Definitions
slot Slot number you want to configure.
port Port number of the interface you want to configure.
port2 Last port number in a range of ports you want to configure.
enable Port link up/down traps are displayed on the NMS.
disable Port link up/down traps are not displayed on the NMS.
on Same as enable .
off Same as disable .
Defaults
Platforms Supported
OmniSwitch 6250
Usage Guidelines
N/A
Examples
-> trap 3/1 port link enable
-> trap 3 port link enable
-> trap 3/1-6 port link enable
Release History
Release 6.6.1; command was introduced.
parameter default
enable | disable | on | off disable