Alcatel-Lucent OmniSwitch 6250, Cli Reference Manual, Page: 632 / 2018

Source Learning Commands
page 18-4 OmniSwitch 6250 CLI Reference Guide November 2009
mac-address-table static-multicast
Configures a static multicast MAC address and assigns the address to one or more egress ports. Packets
received on ports associated with the specified VLAN that contain a destination MAC address that
matches the static multicast address are forwarded to the specified egress ports. Static multicast MAC
addresses are maintained in the Source Learning MAC address table.
mac-address-table static-multicast multicast_address {slot1/port1[-port1a] [slot2/port2[-port2a]...] |
linkagg link_agg} vid
no mac-address-table static-multicast [multicast_address {slot1/port1[-port1a] [slot2/port2[-port2a]...] |
linkagg link_agg} vid]
Syntax Definitions
multicast_address Enter the destination multicast MAC Address to add to the MAC
Address Table (e.g., 01:00:39:59:f1:0c).
slot1/port1[-port1a] The egress slot and port combination that is assigned to the static multi-
cast MAC address. You may enter multiple ports and port ranges.
slot2/port2[-port2a] Additional egress slot and port combinations may be assigned to the
static multicast MAC address. You may enter multiple ports and port
ranges.
link_agg Enter a link aggregate ID number (0–29). See Chapter 12, “Link Aggre-
gation Commands.”
vid VLAN ID number (1–4094).
Defaults
N/A
Platforms Supported
OmniSwitch 6250
Usage Guidelines
•
Use the no form of this command to remove a static multicast MAC address from the Source Learning
MAC Address Table. Note that if no parameters are specified with this form of the command, then all
static multicast addresses are removed.
•
Note that a MAC address is considered a multicast MAC address if the least significant bit of the most
significant octet of the address is enabled. For example, MAC addresses with a prefix of 01, 03, 05, 13,
etc., are multicast MAC addresses.
•
If a multicast prefix value is not present, then the address is treated as a regular MAC address and not
allowed when using the
mac-address-table static-multicast command. Also note that multicast
addresses within the following ranges are not supported:
01:00:5E:00:00:00 to 01:00:5E:7F:FF:FF
01:80:C2:XX.XX.XX
33:33:XX:XX:XX:XX