Alcatel-Lucent OmniSwitch 6250, Cli Reference Manual, Page: 567 / 2018

Distributed Spanning Tree Commands
OmniSwitch 6250 CLI Reference Guide November 2009 page 16-127
show spantree msti
Displays Spanning Tree bridge information for a Multiple Spanning Tree Instance (MSTI).
show spantree msti [msti_id]
Syntax Definitions
msti_id An existing MSTI ID number (0-4094).
Defaults
Platforms Supported
OmniSwitch 6250
Usage Guidelines
•
If an msti_id number is not specified, this command displays the Spanning Tree status, protocol, and
priority values for all MSTIs.
•
This is an explicit Spanning Tree command that displays Spanning Tree bridge information for an
MSTI regardless of which mode (1x1 or flat) is active on the switch.
•
Note that minimal information is displayed when this command is used in the 1x1 mode, as MSTIs are
not active in this mode. In addition, this command will fail if MSTP is not the selected flat mode proto-
col.
•
Note that MSTI 0 also represents the CIST instance that is always present on the switch. To view the
CIST instance using this command, specify zero (0) for the
msti_id number.
Examples
-> bridge mode flat
-> bridge protocol mstp
-> show spantree msti
Spanning Tree Path Cost Mode : AUTO
Msti STP Status Protocol Priority (Prio:SysID)
-----+----------+--------+---------------------
0 ON MSTP 32768 (0x8000:0x0000)
2 ON MSTP 32770 (0x8000:0x0002)
3 ON MSTP 32771 (0x8000:0x0003)
-> show spantree msti 0
Spanning Tree Parameters for Cist
Spanning Tree Status : ON,
Protocol : IEEE Multiple STP,
mode : FLAT (Single STP),
Priority : 32768 (0x8000),
Bridge ID : 8000-00:d0:95:6b:08:40,
parameter default
instance all MSTIs