Alcatel-Lucent OmniSwitch 6250, Cli Reference Manual, Page: 550 / 2018

Distributed Spanning Tree Commands
page 16-110 OmniSwitch 6250 CLI Reference Guide November 2009
bridge 1x1 txholdcount
This command is used to rate limit the transmission of BPDU through a given port for the 1x1 mode
VLAN instance.
bridge 1x1 vid txholdcount {value}
Syntax Definitions
value A numeric value (1–10) that controls the transmission of BPDU through
the port.
Defaults
By default, the txholdcount value is set to 3.
Platforms Supported
OmniSwitch 6250
Usage Guidelines
•
This command is an explicit Spanning Tree command that only applies to the specified VLAN instance
regardless of which operating mode (flat or 1x1) is active on the switch.
•
If the switch is running in the flat mode when this command is used, the specified txholdcount status
for the port is not active for the VLAN instance until the switch is running in the 1x1 Spanning Tree
mode.
•
Note that when a configuration snapshot is taken of the switch, all Spanning Tree commands are saved
in their explicit format.
Examples
-> bridge 1x1 3 txholdcount 3
Release History
Release 6.6.1; command was introduced.
Related Commands
MIB Objects
vStpInsTable
vStpInsBridgeTxHoldCount
bridge mode Selects the Spanning Tree operating mode (flat or 1x1) for the switch.
bridge cist txholdcount Explicit command used to rate limit the transmission of BPDU for the
CIST instance when the switch is operating in either the 1x1 or flat
Spanning Tree mode.