Alcatel-Lucent OmniSwitch 6250, Cli Reference Manual, Page: 431 / 2018

Interswitch Protocol Commands
OmniSwitch 6250 CLI Reference Guide November 2009 page 14-7
show amap
Displays adjacent switches and associated MAC addresses, ports, VLANs, IP addresses, and system
names.
show amap
Syntax Definitions
N/A
Defaults
N/A
Platforms Supported
OmniSwitch 6250
Usage Guidelines
Remote switches that stop sending Hello packets and are connected to an AMAP switch via a hub may
take up to two times the common transmission time to age out of the AMAP database, and no longer
appear in this show command display.
Examples
-> show amap
AMAP is currently enabled,
AMAP Common Phase Timeout Interval (seconds) = 300,
AMAP Discovery Phase Timeout Interval (seconds) = 30
Remote Host Description = falconCmm
Remote Host Base MAC = 00:00:00:00:00:00
Local Interface = 1/2, VLAN = 200
Remote Interface = 3/1, VLAN = 200
Remote IP Address Configured = 1
2.0.0.10
Remote Host Description = falconCmm
Remote Host Base MAC = 00:d0:95:6b:09:40
Local Interface = 3/1, VLAN = 1
Remote Interface = 6/1, VLAN = 1
Remote IP Address Configured = 1
2.0.0.11
output definitions
AMAP is currently The AMAP status: enabled (default) or disabled . Use the amap com-
mand to change the AMAP status for the switch.
AMAP Common Phase Time-
out Interval (seconds) The number of seconds to wait between each Hello packet transmission
during the common phase. Use the
amap common time command to
change this value.