Alcatel-Lucent OmniSwitch 6250, Cli Reference Manual, Page: 187 / 2018

Session Management Commands
OmniSwitch 6250 CLI Reference Guide November 2009 page 6-27
whoami
Displays the current user session.
whoami
Syntax Definitions
N/A
Defaults
N/A
Platforms Supported
OmniSwitch 6250
Usage Guidelines
Use the who command to display all sessions on the switch.
Examples
-> whoami
Session number = 5
User name = admin,
Access type = telnet,
Access port = NI,
IP address = 121.251.17.76,
Read-only domains = None,
Read-only families = ,
Read-Write domains = All ,
Read-Write families = ,
End-User profile =
output definitions
Session Number The session number assigned to the user.
User name User name.
Access type Type of access protocol used to connect to the switch.
Access port Switch port used for access during this session.
Ip Address User IP address.
Read-only domains The command domains available with the user’s read-only access. See
the table beginning on
page 6-28 for a listing of valid domains.
Read-only families The command families available with the user’s read-only access. See
the table beginning on
page 6-28 for a listing of valid families.
Read-Write domains The command domains available with the user’s read-write access. See
the table beginning on
page 6-28 for a listing of valid domains.