Alcatel-Lucent OmniSwitch 6250, Cli Reference Manual, Page: 1755 / 2018

IP Multicast Switching Commands
OmniSwitch 6250 CLI Reference Guide November 2009 page 41-37
ipv6 multicast status
Enables or disables IPv6 Multicast Switching and Routing on the specified VLAN or on the system if no
VLAN is specified.
ipv6 multicast [vlan vid] status [{enable | disable}]
Syntax Definitions
vid VLAN on which to apply the configuration.
enable Enable IPv6 Multicast Switching and Routing.
disable Disable IPv6 Multicast Switching and Routing.
Defaults
Platforms Supported
OmniSwitch 6250
Usage Guidelines
•
If an IPv6 multicast routing protocol is already running on the system, the ipv6 multicast status
command will override this configuration and always enable IPv6 Multicast Switching and Routing.
•
If the IPv6 Multicast Switching and Routing is already enabled on the system, then the VLAN configu-
ration will override the system's configuration.
•
You can also restore the MLD querying to its default (i.e., disabled) status on the system if no VLAN
is specified, by using only
ipv6 multicast status (e.g., ipv6 multicast status).
•
You can also restore the MLD querying to its default (i.e., disabled) status on the specified VLAN, by
using only
ipv6 multicast vlan vid status (e.g., ipv6 multicast vlan 2 status).
Examples
-> ipv6 multicast status enable
-> ipv6 multicast status disable
-> ipv6 multicast status
-> ipv6 multicast vlan 2 status enable
-> ipv6 multicast vlan 2 status disable
-> ipv6 multicast vlan 2 status
Release History
Release 6.6.1; command was introduced.
parameter default
enable | disable disable