Alcatel-Lucent OmniSwitch 6250, Cli Reference Manual, Page: 1614 / 2018

QoS Policy Commands
page 39-118 OmniSwitch CLI Reference Guide November 2009
policy action maximum bandwidth
Configures a maximum bandwidth value for a policy action.
policy action action_name maximum bandwidth bps
policy action action_name no maximum bandwidth
Syntax Definitions
action_name The name of the action.
bps The desired value for maximum bandwidth, in bits per second. The
value may be entered as an integer (for example,
10000 ) or with abbre-
viated units (for example, 10k ). If the value is entered in bits per second,
the switch rounds the value up to the nearest thousand.
Defaults
N/A
Platforms Supported
OmniSwitch 6250
Usage Guidelines
•
Use the no form of the command to remove a maximum bandwidth value from an action.
•
Note that the bandwidth may be entered in bits per second. Alternatively, the bandwidth may be
entered in abbreviated units (
1k , 2k , etc). If the bandwidth value is entered in bytes, the switch rounds
the value to the nearest thousand bytes. For example, if you enter 1 to 1024, the result is 1K. If you
enter 1025 to 2048, the result is 2K.
Examples
-> policy action action4 maximum bandwidth 10000
-> policy action action4 maximum bandwidth 10k
-> policy action action4 no maximum bandwidth
Release History
Release 6.6.1; command was introduced.