Alcatel-Lucent OmniSwitch 6250, Cli Reference Manual, Page: 1530 / 2018

QoS Policy Commands
page 39-34 OmniSwitch CLI Reference Guide November 2009
policy condition
Creates a QoS policy condition. The condition determines what parameters the switch uses to classify
incoming flows. Condition parameters may be configured when the condition is created; or parameters
may be configured for an existing condition. At least one parameter must be configured for a condition.
This section describes the base command. Optional keywords are listed below and described as separate
commands later in this chapter. (Options may be used in combination but are described separately for ease
in explanation.) Use the
no form for keywords to remove a parameter from the condition.
Some condition parameters may not be supported depending on the platform you are using. Also some
condition parameters may not be supported with some action parameters. See the condition/action tables in
the
OmniSwitch 6250 Network Configuration Guide .
policy condition condition_name
[source ip ip_address [mask netmask]]
[source ipv6 {any | ipv6_address [mask netmask]}
[destination ip ip_address [mask netmask]]
[destination ipv6 {any | ipv6_address [mask netmask]}
[multicast ip ip_address [mask netmask]]
[source network group network_group]
[destination network group network_group]
[multicast network group multicast_group]
[source ip port port[-port]]
[destination ip port port[-port]]
[source tcp port port[-port]]
[destination tcp port port[-port]]
[source udp port port[-port]]
[destination udp port port[-port]]
[ethertype etype]
[established]
[tcpflags {any | all} flag [mask flag]
[service service]
[service group service_group]
[icmptype type]
[icmpcode code]
[ip protocol protocol]
[ipv6]
[tos tos_value tos_mask]
[dscp {dscp_value[-value} [dscp_mask]]
[source mac mac_address [mask mac_mask]]
[destination mac mac_address [mask mac_mask]]
[source mac group group_name]
[destination mac group mac_group]
[source vlan vlan_id]
[destination vlan vlan_id]
[802.1p 802.1p_value]
[source port slot/port[-port]]
[source port group group_name}