Alcatel-Lucent OmniSwitch 6250, Cli Reference Manual, Page: 1464 / 2018

QoS Commands
page 38-36 OmniSwitch CLI Reference Guide November 2009
qos port
Configures QoS parameters for a physical port. This section describes the base command with a single
required option (
slot/port ).
In lieu of these options, the base command ( qos port ) may be used with other keywords to set up a QoS
configuration on a per port basis. These keywords are listed here and described as separate commands later
in this chapter. In addition, some keywords have a
no form to remove the parameter or return it to its
default.
qos port slot/port
[servicing mode]
[trusted]
[maximum bandwidth]
[default 802.1p value]
[default dscp value]
[default classification {802.1p | tos | dscp}]
Syntax Definitions
slot/port The physical slot and port number. For example: 4/1.
Defaults
•
Mobile ports and ports enabled for 802.1Q are always trusted; by default, any other ports are not
trusted.
•
By default, QoS ports do not preempt queues of lower priority.
Platforms Supported
OmniSwitch 6250
Usage Guidelines
Use the trusted option to change the trust mode for the port.
Examples
-> qos port 3/1 trusted
-> qos port 4/2 no trusted
Release History
Release 6.6.1; command was introduced.