Alcatel-Lucent OmniSwitch 6250, Cli Reference Manual, Page: 1357 / 2018

RIP Commands
OmniSwitch 6250 CLI Reference Guide November 2009 page 33-17
ip rip interface auth-type
Configures the type of authentication that will be used for the RIP interface. By default, there is no authen-
tication used for RIP. However, you can configure a password for a RIP interface. To configure a pass-
word, you must first select the authentication type (simple or MD5), then configure a password.
ip rip interface {interface_name} auth-type {none | simple | md5}
Syntax Definitions
interface_name The name of the interface.
none No authentication will be used.
simple Simple authentication will be used.
md5 MD5 authentication will be used.
Defaults
Platforms Supported
OmniSwitch 6250
Usage Guidelines
Regardless of which authentication type is used (simple or MD5), both switches on either end of a link
must share the same password.
Examples
-> ip rip interface rip-1 auth-type none
Release History
Release 6.6.1; command was introduced.
Related Commands
MIB Objects
rip2IfConfTable
rip2IfConfAddress
rip2IfConfAuthType
parameter default
none | simple none
ip rip interface auth-key Configures the text string that will be used as the password for the
RIP interface.