Alcatel-Lucent OmniSwitch 6250, Cli Reference Manual, Page: 1172 / 2018

IPv6 Commands
page 30-6 OmniSwitch 6250 CLI Reference Guide November 2009
ipv6 address
Configures an IPv6 address for an IPv6 interface on a VLAN. There are different formats for this
command depending on the address type.
ipv6 address ipv6_address /prefix_length [anycast] {if_name | loopback}
no ipv6 address ipv6_address [anycast] {if_name | loopback}
ipv6 address ipv6_prefix eui-64 {if_name | loopback}
no ipv6 address ipv6_prefix eui-64 {if_name | loopback}
Syntax Definitions
ipv6_address IPv6 address.
/prefix_length The number of bits that are significant in the IPv6 address (mask).
(3..128).
anycast Indicates the address is an anycast address.
eui-64 Append an EUI-64 identifier to the prefix.
if_name Name assigned to the interface.
loopback Configures the loopback interface.
Defaults
N/A
Platforms Supported
OmniSwitch 6250
Usage Guidelines
•
Use the no form of this command to delete an address.
•
You can assign multiple IPv6 addresses to an IPv6 interface.
•
No default value for prefix length.
•
The “eui” form of the command is used to add or remove an IPv6 address for a VLAN using an EUI-64
interface ID in the low order 64 bits of the address.
•
To enable IPv6 routing you must first create a VLAN, then create an IPv6 interface on the VLAN. See
Chapter 22, “VLAN Management Commands,” for information on creating VLANs.
Examples
-> ipv6 address 4132:86::19A/64 Test_Lab
-> ipv6 address 2002:d423:2323::35/64 Test_Engr