Alcatel-Lucent OmniSwitch 6250, Cli Reference Manual, Page: 1062 / 2018

IP Commands
page 29-14 OmniSwitch 6250 CLI Reference Guide November 2009
ping
Tests whether an IP destination can be reached from the local switch. This command sends an ICMP echo
request to a destination and then waits for a reply. To ping a destination, enter the
ping command and
enter either the destination’s IP address or hostname. The switch will ping the destination using the default
frame count, packet size, interval, and timeout parameters (6 frames, 64 bytes, 1 second, and 5 seconds
respectively). You can also customize any or all of these parameters as described below.
ping {ip_address | hostname} [count count] [size packet_size] [interval seconds] [timeout seconds]
Syntax Definitions
ip_address IP address of the system to ping.
hostname DNS name of the system to ping.
count Number of frames to be transmitted.
packet_size Size of the data portion of the packet sent for this ping, in bytes. Valid
range is 1–60000.
interval seconds Polling interval. The switch will poll the host at time intervals specified
in seconds.
timeout seconds Number of seconds the program will wait for a response before timing
out.
Defaults
Platforms Supported
OmniSwitch 6250
Usage Guidelines
If you change the default values they will only apply to the current ping. The next time you use the ping
command, the default values will be used unless you again enter different values.
parameter default
count 6
packet_size 64
interval seconds 1
timeout seconds 5