Alcatel-Lucent MDR-8000, User Manual, Page: 89 / 130

5-31
Table 5 - 6 Module Replacement Matrix
MODULE/UNIT REMOVAL/REPLACEMENT
PROCEDURE CHECKS/ADJUSTMENTS
PROCEDURE
AE-27AF Relay Interface No Special Procedure Required None Required
AE-37Y Controller Para. 5.14 None Required
CE-16BB Power Supply Para. 5.13 None Required
Fuse No Special Procedure Required.
Refer to Operations Section for
Location.
DX-35M DS1/E1 I/O Interface No special procedure required. None Required
DX-35N DS3 I/O Interface
(Early Versions)
Para. 5.15 Para. 5.15 and Table 5 - 9
DX-35P OC3/STM-1
I/O Interface
Para. 5.16 None Required
DX-35R/S ETH I/O Interface Para. 5.16 None Required
UD-35( ) Transmitter Para. 5.17 Para. 5.18, Para. 5.19,
Para. 5.20, and Para. 5.21
Crystal Oscillator Subboard Figure 5 - 15 The Crystal Oscillator Sub-
board and crystal part numbers
define this unit. The crystal is sol-
dered to the oscillator subboard
and factory tuned to the custom-
ers requirements.
Capacity Key Figure 5 - 16
UD-36( ) Receiver Para. 5.22 Para. 5.23
2
Crystal Oscillator Subboard Figure 5 - 22 The Crystal Oscillator Sub-
board and crystal part numbers
define this unit. The crystal is sol-
dered to the oscillator subboard
and factory tuned to the custom-
ers requirements.
Capacity Key Figure 5 - 23
UD-51( ) Power Amplifier
Hot-Standby Shelf
CommPak Indoor Shelf Para. 5.24
Appendix A on enclosed CD Para. 5.25
LBO/AUX/Line Interface
Hot-Standby Shelf
CommPak Indoor Shelf
Maintenance Section on
enclosed CD
Appendix H on enclosed CD
No Special Procedure Required
No Special Procedure Required
RF Switch Maintenance Section on
enclosed CD No Special Procedure Required
(1)
If ATPC is in use, it must be provisioned disabled or locked high before removing controller.
(2)
Applicable to older versions of RCVR with Freq Cont on front panel.