Alcatel-Lucent Data Multiplexer Explore 1665, Installation Manual, Page: 34 / 408

............................................................................................................................................................................................................................................................
Planning Equipment and cable installation for 1665 Data Multiplexer
(1665 DMX)
1 - 4
365-372-304R7.1
Issue 1, November 2007
Mounting options
The mounting brackets on the 1665 DMX High-Capacity shelf are designed to allow for
mounting in the following:
•
Standard 23-inch wide network bay frames
The recommended network bay frames are the ED-8C500 and the ED-8C501 (rear
access only). Refer to
Figure 1-4, “Typical 1665 DMX High-Capacity shelf bay
mounting arrangements” (p. 1-12) for 1665 DMX shelf placement in a network bay
frame.
•
Seismic 23-inch network bay frame
The ED-8C800-500 and ED-8C801-501 seismic network bay frames are designed for
use in all earthquake zones, and in general, do not require top support at the 7-foot
level. These frames meet Pacific Bell Equipment Framework Standard PBS-000-
102PT.
•
19-inch bay frames
•
23-inch wide EIA-Type bay frames
1665 DMX added to the Lambda Unite
®
MSS configurations
In order for the 1665 DMX shelf to be placed in a NEBS-2000 Cabinet frame combined
with Lambda Unite
®
MSS, mounting kit 848856514 is required. For a more complete
view of mounting the 1665 DMX into the Lambda Unite
®
Frame, see SIG-L-WW-161A,
1665 DMX
added to the Lambda Unite
®
MSS Configurations.
Cabling checklist
This section briefly describes cabling information. For information regarding available
cable lengths and ordering comcodes, refer to ED8C871-10.
Table 1-1, “Cable requirements and options” (p. 1-5) lists available cables.
1 Torque Wrench
ITE-5952 A torque wrench (50-250 IN-LBS) is used when
tightening the 1665 DMX High-Capacity shelf to
the frame. It is also used when reattaching the
mounting brackets to the 1665 DMX High-Capacity
shelf.
1 Ohmmeter ITE-6379 An ohmmeter is required to verify that the 1665
DMX is properly grounded.
______________________________________________________________
* Registered trademark of Thomas & Betts Corporation
† Registered trademark of Paladin Corporation.
Quantity Description Comments