Alcatel-Lucent Data Multiplexer Explore 1665, Installation Manual, Page: 27 / 408

1665 Data Multiplexer (1665 DMX) physical installation
and powering
............................................................................................................................................................................................................................................................
365-372-304R7.1
Issue 1, November 2007
I - 3
1 Thomas & Betts
*
R-
5648B Crimping Tool
The crimping tool and wire stripper are only
required if installing DS3 cables. The replacement
cassette is for the wire stripper tool.
1 Paladin
†
Coaxial Wire
Stripper R-5648B
Replacement Paladin
†
Cassette R-5648B D5
1 Wire-Wrap Gun
R-4496A The wire-wrap gun is required for terminating
DS1 cable and must be able to accommodate 24
gauge wire.
1 ESD Wrist Strap
R-4987C A wrist strap must be worn when handling circuit
packs. Use the electrostatic discharge (ESD) jack
provided on the shelf.
1 Torque Wrench
R-5952 A torque wrench (50-250 IN-LBS) is used when
tightening the
1665 DMX
shelf to the frame. It is
also used when reattaching the mounting brackets
to the 1665 DMX shelf.
1 Multimeter (Optional)
ITE-6379C The voltmeter must be capable of measuring DC
voltage in the 40 to 60 volt range. The use of the
voltmeter is optional since the shelf will alarm or
shut down if the proper voltage is not supplied.
1 Ohmmeter
ITE-6379C
An ohmmeter is required to verify that the
1665
DMX
is properly grounded.
1 DS1 Error Rate Test Set
ITE-7113 A DS1 error rate test set is required for testing of
DS1 cabling. A T-BERD 2209 or equivalent is
recommended.
1 DS3 Error Rate Test Set
ITE-7113 A DS3 error rate test set is required for testing of
DS3 cabling. A T-BERD 209 or equivalent is
recommended.
1 SONET Optical Test Set An OC3, OC12 or OC48 test set as required for
testing of optical circuit packs. An Agilent
OmniBER 718 or equivalent is recommended.
Quantity Description Comments