Alcatel-Lucent Data Multiplexer Explore 1665, Installation Manual, Page: 252 / 408

............................................................................................................................................................................................................................................................
Operational tests
5 - 2
365-372-304R7.1
Issue 1, November 2007
Tools, test equipment and accessories
Listed below are the tools, test equipment and accessories necessary to perform the
procedures in this section.
Quantity Description Comments
Screwdriver(s) A screwdriver(s) with the appropriate head(s) is (are)
required for securing the mounting screws,
repositioning the mounting brackets, installing the
interfacing cables, and for setting the circuit breakers
to the OFF position.
1 ESD Wrist Strap A wrist strap must be worn when handling circuit
packs. Use the electrostatic discharge (ESD) jack
provided on the shelf.
1 Multimeter
(Optional) The voltmeter must be capable of measuring DC
voltage in the 40 to 60 volt range. The use of the
voltmeter is optional since the shelf will alarm or shut
down if the proper voltage is not supplied.
1 DS1 Error Rate Test
Set A DS1 error rate test set is required for testing of DS1
cabling. A T-BERD 211 or equivalent is
recommended.
1 DS3 Error Rate Test
Set A DS3 error rate test set is required for testing of DS3
cabling. A T-BERD 305 or equivalent is
recommended.
1 SONET Optical Test
Set An ONC3, OC-12, or OC-48 test set is required for
testing of optical circuit packs. An Agilent OmniBER
718 or equivalent is recommended.
2 LC-type Optical
Fiber Jumper
(108918269) Two optical fiber jumpers with LC type connectors
are required to optically loop the
1665 DMX
shelf
for test purposes.
2 15 dB LC-type LBO
(108279480) Two 15-dB LBOs are required when optically looping
the
1665 DMX
shelf for test purposes.
2 20-dB LC-type LBO
(108279530) Two 20-dB LBOs are required when optically looping
the
1665 DMX
shelf equipped with LNW60.
1 Personal Computer
(PC) See Chapter 3, “Software download and circuit pack
installation” , “PC minimum requirements” (p. 3-2) .
1 CIT Interface Cable 8-ft. long RJ45 to 9-pin D-sub serial cable (Comcode
848748869).