Alcatel-Lucent Data Multiplexer Explore 1665, Installation Manual

Page: 132 / 408

............................................................................................................................................................................................................................................................
Description Powering and initial circuit pack installation for 1665 Data
Multiplexer (1665 DMX)
2 - 2
365-372-304R7.1
Issue 1, November 2007
............................................................................................................................................................................................................................................................
Description
Overview
This section should be performed on all shelf installations.
Tools, test equipment and accessories
Listed below are the tools, test equipment and accessories necessary to perform the
procedures in this section.
Quantity Description Comments
Screwdriver(s) A screwdriver(s) with the appropriate head(s) is (are)
required for securing the mounting screws,
repositioning the mounting brackets, installing the
interfacing cables, and for setting the circuit breakers
to the OFF position.
1 ESD Wrist Strap A wrist strap must be worn when handling circuit
packs. Use the electrostatic discharge (ESD) jack
provided on the shelf.
1 Multimeter
(Optional) The voltmeter must be capable of measuring DC
voltage in the 40- to 60-volt range. The use of the
voltmeter is optional since the shelf will alarm or
shut down if the proper voltage is not supplied.
1 Personal
Computer (PC) Required to run the WaveStar
®
CIT software. See PC
minimum requirements (p. 3-2) .
1 CIT Interface
Cable 8-ft. long RJ45 to 9-pin D-sub serial cable (Comcode
848748869). Required to connect the PC to the CIT
jack on the front of the SYSCTL circuit pack.