Registering the telephone
8AL90386ENABed01
46 /76
conditions, it is recommended to perform registration in a place where a base station is in direct visibility
within a 20 m range. If base station is not visible the range shall be lowered.
During registration phase in a multi-system environment, all systems are scanned without priority. The
system is selected when the signal strength is above a certain level and registration matches.
7.2 Registering the telephone on other systems
The telephone can be registered on several systems (maximum of 4).
Note: the input is usually reserved for use with your main Alcatel-Lucent Enterprise system. You can select
the other inputs to register the telephone under another system (Alcatel-Lucent Enterprise or other system).
To make a new registration, when the telephone has already been registered on one or more
systems, proceed as follows:
1. Prepare your system for registration (see the system installation manual or consult your installation
manager).
2. When the system is ready:
•
Access MENU.
•
Install
•
Enter the PIN Code.
•
Apply (
Ok
).
•
Register
•
Select a system.
•
Enter PARK code (Enter nothing if not mandatory).
•
Apply (
Ok
).
•
Enter access code (Enter nothing if not mandatory).
•
Apply (
Ok
).
•
Power mode:
Select the power mode using the corresponding softkeys:
Normal
/
50 mW power
(you
are advised not to select the 50 mW power mode unless required. The '50mW power
mode' is intended for hazardous sites such as nuclear plants where it is requested that
emissions do not exceed the maximum value.).
•
Enhanced Security
•
Yes / No
Call from encrypted system to un-encrypted system is accepted (yes) or rejected (no)
•
Select 'Modic' mode:
o
8254 DECT Handset:
1. Select '8254 Modic' if you connect the handset to an OXO Connect
R4.0 and more, otherwise select '8232 Modic'.
2. Select '8232 Modic' if you connect the handset in IP-DECT mode.
o
8234 DECT Handset:
1. Select '8234 Modic' if you connect the handset to an OXO Connect
R4.0 and more, otherwise select '8232 Modic'.
2. Select '8232 Modic' if you connect the handset in IP-DECT mode.
Launch subscription.
ghi
kl
p r s
t uv
ghi
kl
p r s
t uv
ghi
kl
p r s
t uv
