Alcatel-Lucent 7950 XRS Series, Configuration Manual

Page: 423 / 502

System Management
7950 SR OS Basic System Configuration Guide Page 423
LLDP Ethernet Port Commands
lldp
Syntax lldp
Context config>port>ethernet
Description
This command enables the context to configure Link Layer Discovery Protocol (LLDP) parameters on the
specified port.
dest-mac
Syntax dest-mac { bridge-mac }
Context config>port>ethernet>lldp
Description
This command configures destination MAC address parameters.
Parameters
bridge-mac — Specifies destination bridge MAC type to use by LLDP.
Values
nearest-bridge — Specifies to use the nearest bridge.
nearest-non-tpmr — Specifies to use the nearest non-Two-Port MAC Relay (TPMR) .
nearest-customer — Specifies to use the nearest customer.
admin-status
Syntax admin-status { rx | tx | tx-rx | disabled }
Context config>port>ethernet>lldp>dstmac
Description
This command specifies the administratively desired status of the local LLDP agent.
Parameters
rx — Specifies the LLDP agent will receive, but will not transmit LLDP frames on this port.
tx — Specifies that the LLDP agent will transmit LLDP frames on this port and will not store any
information about the remote systems connected.
tx-rx — Specifies that the LLDP agent will transmit and receive LLDP frames on this port.
disabled — Specifies that the LLDP agent will not transmit or receive LLDP frames on this port. If there is
remote systems information which is received on this port and stored in other tables, before the port's
admin status becomes disabled, then the information will naturally age out.