Alcatel-Lucent 7950 XRS Series, Configuration Manual

Page: 103 / 502

Root Commands
7950 SR OS Basic System Configuration Guide Page 103
Default
Base
wait-time wait-time — Specify the number of seconds to wait for the response.
Values
1 — 60
mtrace
Syntax mtrace source [ ip-address | dns-name ] [ group grp-ip-address ] [ destination dst-ip-address ] [ hop
hop ] [ router router-instance ] [ wait-time wait-time ]
Context <GLOBAL>
Description
This command traces a multicast path from a source to a receiver.
Parameters
ip-address — Specify the ip-address of the multicast capable target router.
dns-name — Specify the DNS name (if DNS name resolution is configured).
Values
63 characters maximum
group group-ip-address — Specify the multicast address or DNS name of the group that resolves to the
multicast group address that will be used. If the group is not specified, address 224.2.0.1 (the MBone
audio) will be used. This will suffice if packet loss statistics for a particular multicast group are not
needed.
destination dst-p-address — Specify either the IP address or the DNS name of the unicast destination. If
this parameter is omitted the IP address of the system where the command is entered will be used. The
receiver parameter can also be used to specify a local interface address as the destination address for
sending the trace query. The response will also be returned to the address specified as the receiver.
hop hop — Specify the maximum number of hops that will be traced from the receiver back toward the
source.
Values
1 — 255
Default
32 hops (infinity for the DVMRP routing protocol).
router-instance — Specify the router name or service ID.
Values
router-name : Base, management
service-id : 1 — 2147483647
Default
Base
wait-time wait-time — Specify the number of seconds to wait for the response.
Values
1 — 60
password
Syntax password
Context <ROOT>
Description
This command changes a user CLI login password.