Alcatel-Lucent 7750 SR-OS, Configuration Manual

Page: 636 / 674

Page 636 7750 SR OS Router Configuration Guide
Modifying Cflowd Collector Parameters
Use the following commands to modify cflowd collector and aggregation parameters:
CLI Syntax:
config>cflowd#
collector ip-address [: port ] [version version ]
no collector ip-address [: port ]
[no] aggregation
[no] as-matrix
[no] destination-prefix
[no] protocol-port
[no] raw
[no] source-destination-prefix
[no] source-prefix
[no] autonomous-system-type [ origin | peer ]
[no] description description-string
[no] shutdown
template-set {basic | mpls-ip | l2-ip}
If a specific collector UDP port is not identified then, by default, flows are sent to port 2055.
The following displays basic cflowd modifications:
A:ALA-1>config>cflowd# info
-----------------------------------------
active-timeout 60
overflow 2
rate 10
collector 10.10.10.1:2000 version 5
description "AS info collector"
exit
collector 10.10.10.2:5000 version 8
aggregation
source-prefix
raw
exit
description "
Test collector "
exit
-----------------------------------------
A:ALA-1>config>cflowd#