Alcatel-Lucent 7705 SAR-A, Installation Manual

Page: 114 / 154

Establishing Router Management Connections
114 7705 SAR-A Chassis Installation Guide
To establish a console connection:
Step 1. Connect the terminal to the Console port on the front panel ( Figure 26 ) using an
RJ-45 CAT5e cable.
Step 2. Power on the terminal.
Step 3. Establish the connection by pressing the <Enter> key a few times on your terminal
keyboard.
Step 4. At the router prompt, enter the login and password.
The default login is
admin
.
The default password is
admin
.
SSH Connection
SSH access provides the same options for user and administrator access as those available
through the console port or Telnet; however, SSH is more secure than Telnet. You can access
the router with an SSH connection from a PC or workstation connected to the network once
the following conditions are met:
• the router has successfully initialized
• the Management port ( Figure 27 ) has been configured using the
bof>address
command (see CLI Syntax )
CLI Syntax:
bof
address ip-prefix/ip-prefix-length [primary |
secondary]
where:
address
is an IPv4 or IPv6 address
Figure 27: Management Port Connection
Note: SSH connection attempts after a reboot may generate key warnings as the node
generates new SSH keys on each reboot. To avoid these key warnings, enable key
preservation using the
config>system>security>ssh>preserve-key
command.
7705 SAR-A
Mgmt
ToD Out
Lnk Act
Sync In
+Batt A -Batt A +Batt B -Batt B
Console
8 12 11 10 9 7 6 5 4B 3B 2B 1B 1A
Status
2A 3A 4A
Act Lnk Act Lnk Act Lnk Act Lnk
Stat Stat Stat Stat
2 4 6 8
1 3 5 7
Lnk Act Lnk Act Lnk Act Lnk Act
Stat Stat Stat Stat
T1/E1 Ethernet
-48 VDC
23320
Management port