Alcatel-Lucent Enterprise 8088, Manual

Page: 8 / 30

1.6 Features
The board must provide the following features:
WLAN:

TX and RX low-density parity check (LDPC) support for improved range and power
efficiency.

Single-stream spatial multiplexing up to 433.3 Mbps data rate.

Supports 1 antenna with one for WLAN & Bluetooth shared port

20, 40, 80 MHz channels with optional SGI (256 QAM modulation)

Supports standard SDIO v3.0 HOST interfaces.
Bluetooth:

Give dual mode BT connectivity (Classic & Low Energy)

Complies with Bluetooth Core Specification Version 5.0 with provisions for supporting
future, With Bluetooth Class2 transmitter operation.

Supports extended synchronous connections (eSCO), for enhanced voice quality by
allowing for retransmission of dropped packets

Adaptive frequency hopping (AFH) for reducing radio frequency interference.

Interface to the motherboard with UART and PCM, UART up to 4Mbps.

Integrate PCB antenna, which will be shared Bluetooth and WLAN
2 General Requirements
2.1 Standards
2.1.1 BT related certification
On the Bluetooth.org website, the existing certifications of BT solutions are listed.
The certification strategy will be as
follows:

Make a certification for the board, with embedded low part of the BT stack, and antenna

Make BTWDB a module certification, where we can take benefit of the module
certification