Working with Files
35
Summary and Thresholds. A summary of average, minimum, and maximum
values:
Volt .................... Cell voltage.
Res ..................... Cell resistance.
SG ...................... Specific gravity.
Temp .................. Temperature.
Int R1, 2, 3, 4 ..... Intercell resistance 1, 2, 3 and 4.
Cell Data listed for each cell:
Volt .................... Cell voltage.
Res ..................... Cell resistance.
Int R1 ................. Intercell resistance R1.
Int R2 ................. Intercell resistance R2.
Int R3 ................ Intercell resistance R3.
Int R4 ................. Intercell resistance R4.
SG ...................... Specific gravity.
Temp .................. Temperature.
Set the thermal printer power switch to on. If the Status LED is on, connect
the printer charger. A flashing Status LED means high temperature or paper
out. Refer to the printer manual on the program CD.
CAUTION
: Charge the battery with printer power off. The printer cannot
operate from the charger. Minimum charge time is one hour. Do not leave
the charger connected; this will shorten battery life.
Shift+Print
To print to the thermal printer, press Shift+Print. On the Select Headers
screen, select items for the report: site information, statistics, faults, and
thresholds. Press Next, select data you want included, then press Next.
TIP
: Use the Arrows to highlight an item, then press Enter to select or
unselect it.
Figure 16. Print Options
Align the Cellcorder and printer IR ports, and press Continue. The printer
Status LED flashes while data is being received.
