Alaxala AX3630S, Software Manual

Page: 530 / 875

21. IEEE802.1X
502
dot1x vlan dynamic supplicant-detection
Specifies the behavior when a new terminal is detected.
Syntax
To set or change information:
dot1x vlan dynamic supplicant-detection {disable | full | shortcut | auto}
To delete information:
no dot1x vlan dynamic supplicant-detection
Input mode
(config)
Parameters
{disable | full | shortcut | auto}
Specifies the behavior when a new terminal is detected.
disable
Suppresses EAP-Request/Identity transmission processing for detecting a new terminal.
Specify this parameter if a supplicant operates abnormally if the authentication sequence
is omitted in order to decrease switch load.
If this parameter is specified, authentication processing for a supplicant for which
authentication cannot be initiated from the terminal cannot be started.
full
Suppresses the authentication sequence from being skipped to reduce the load on the
Switch during EAP-Request/Identity transmission for new terminal detection, and
performs normal re-authentication processing for authenticated terminals. Specify this
parameter when you use both a supplicant that operates abnormally if the authentication
sequence is skipped in order to decrease the load and a supplicant that cannot start
authentication if
disable
is specified.
If this parameter is specified, the maximum number of terminals per authentication unit
must be 20 or less.
shortcut
Omits the authentication sequence of an authenticated terminal during EAP-Request/
Identity transmission for detecting a new terminal to reduce the load. Specify this
parameter for a supplicant that is unable to initiate authentication from a terminal.
If this parameter is specified, some supplicants might not operate correctly, and
communication is temporarily stopped.
auto
Suppresses EAP-Request/Identity transmission processing for detecting a new terminal,
and separately sends EAP-Request/Identity packets and performs authentication when a
frame is received from a terminal.
1. Default value when this parameter is omitted:
This parameter cannot be omitted.
2. Range of values:
disable
,
full
,
shortcut
, or
auto