Alaxala AX3630S, Software Manual

Page: 335 / 875

17. Flow Detection Modes and Flow Operations
307
flow detection mode
Sets the flow detection mode for filtering and QoS functionality for the receiving-side interface.
This command changes the allocation pattern for the maximum number of entries in a hardware
table.
By changing the allocation pattern according to the operating mode, you can collect hardware
resource information in the necessary tables and use it.
This command is used to set the basic operating conditions for hardware. If you want to change the
distribution pattern, you must clear the settings of the
ip access-group
,
ipv6 traffic-filter
,
mac access-group
,
ip qos-flow-group
,
ipv6 qos-flow-group
, and
mac qos-flow-group
commands for the receiving-side and sending-side interfaces.
Accordingly, you must set this command during the first step of actual operation. We recommend
that you do not make any changes during operation.
If you do not set this command or if the information has been deleted,
layer3-2
returns to its
default state.
Syntax
To set or change information:
flow detection mode {layer3-1 | layer3-2 | layer3-3 | layer3-4 | layer3-5 | layer3-6 |
layer3-dhcp-1} [AX3640S]
flow detection mode {layer3-1 | layer3-2 | layer3-3 | layer3-4 | layer3-dhcp-1} [AX3630S]
To delete information:
no flow detection mode
Input mode
(config)
Parameters
{layer3-1 | layer3-2 | layer3-3 | layer3-4 | layer3-5 | layer3-6 | layer3-dhcp-1} [AX3640S]
{layer3-1 | layer3-2 | layer3-3 | layer3-4 | layer3-dhcp-1} [AX3630S]
Specifies the flow detection mode.
1.
Default value when this parameter is omitted:
This parameter cannot be omitted.
2. Range of values:
None
The following table describes the commands applicable to the flow detection modes.
Table 17-1: Commands applicable to flow detection mode [AX3640S]
Flow detection mode Applicable command
mac ip ipv6
access-group access-group traffic-filter
qos-flow-group qos-flow-group qos-flow-group
layer3-1 Y Y N