Alaxala AX3630S, Software Manual

Page: 169 / 875

10. Link Aggregation
141
channel-group max-detach-port
Limits the maximum number of detached ports in the applicable link aggregation channel group.
Syntax
To set or change information:
channel-group max-detach-port <number>
To delete information:
no channel-group max-detach-port
Input mode
(config-if)
Parameters
<number>
Specifies the maximum number of ports that can be detached from a channel group used for
link aggregation for reasons such as a link down. When 0 is specified, no ports can be
detached. Therefore, if a link goes down, the whole channel group goes down.
1.
Default value when this parameter is omitted:
This parameter cannot be omitted.
2. Range of values:
0 or 7
Default behavior
7 is set as the limit on the maximum number of detached ports.
Impact on communication
Channel groups might go down due to a limit on the number of detached ports.
When the change is applied
The change is applied immediately after setting values are changed.
Notes
1. This command is effective only when LACP-based link aggregation is used.
2. If you specify the
max-detach-port
command, match its settings to the settings of the
destination device.
3. If
0
is entered for the
max-detach-port
command, the effect is the same as when
7
is entered
for the
max-detach-port
command in on mode (this is the default when nothing is entered
for
max-detach-port
).
4. If you set a restriction on the number of detached ports (
max-detach-port
) to connect a
Switch to a device from other manufacturers, set a higher LACP system priority level for the
Switch.
5. If you change the value for <number> to
0
, all ports registered for the channel group change
to
Blocking
(communication interrupted) while some ports registered in the channel group
for the applicable link aggregation are degraded.
Related commands
interface port-channel