en
SAFETY INSTRUCTIONS
Risk of accident due to rolling trailer.
Secure the trailer with wheel chocks prior to
uncoupling!
Risk of accident due to rolling trailer.
Always secure the trailer with chocks prior to
performing any maintenance and care jobs!
An AL-KO axle is not allowed to be welded!
Undetected bearing damage can progress to
the point that the bearing is completely de-
stroyed and this will lead to the wheel run-
ning off the axle. If you suspect bearing da-
mage, see your specialist service centre! Trai-
lers should only be operated in perfect condi-
tion!
In the event of faults while driving, contact a
trained specialist or our AL-KO Service.
Type information is not allowed to be rendered
illegible due to painting or being covered by
components
MAINTENANCE AND CARE
CAUTION!
All maintenance and repair work should
only be performed by trained personnel.
See an service centre for all faults and
unusual driving noises.
ADVICE
To avoid white rust formation (defective
appearance):
Ensure sufficient air circulation when
storing!
After winter journeys, wash the
hot dip galvanised components with
clean water!
Maintenance intervals
ADVICE
Maintenance intervals must be complied
with!
The maintenance intervals will be shorter
if there is heavy use.
Initial inspection after 500 km or 6 months
Check the axial play of the wheel hub bearing,
re-adjust if necessary.
Use new locking nut to adjust the axial play!
Every 1500 km or 6 months
Check the axial play of the wheel hub bearing,
re-adjust if necessary.
Use new locking nut to adjust the axial play!
ADVICE
Maintenance instructions for the esta-
blishment and development of other
components, refer to the manufacturer's
documentation
Storage
CAUTION!
Risk of accident due to rolling trailer.
Always secure the trailer with chocks
prior to performing any maintenance
and care jobs!
Replacement parts
ADVICE
Replacement parts are safety parts!
For the installation of replacement parts into
our products, we recommend the use of origi-
nal parts, or parts that we have expressly ap-
proved for installation.
For the clear identification of replacement
parts, our service stations require the repla-
cement part identification number (ETI).
1 655 894_d
3
