AL-KO SOLO Robolinho 1200, Manual

Page: 53 / 432

457825_a 53
Settings
2. Activating/deactivating the rain sensor:
■
or
Activate
:
Activate the rain sensor.
■
or Deactivate :
Deactivate the rain sensor.
3. Setting the delay of the rain sensor:
■
or
* After rain delay
■
xx hours xx minutes
Select the required value for the delay
with or and accept with .
4. Setting the sensitivity of the rain sensor:
■
or * Rain sensitive
■
Select the required value for the sensitivi-
ty with or and accept with .
7.5 Setting the mowing program
7.5.1 Setting the mowing program – General
1. Call up the main menu with .
2. or
* Programs
3. Select the menu item with or and ac-
cept with .
4. Carry out the settings.
Note: The menu items are described in the
following sections.
7.5.2 Setting the start points
Teaching-in start points
1. Place the appliance in the base station.
2. Switch on the appliance with .
3. Call up the main menu with .
4. or
* Programs
5. or
* Entry Point
6. or
* Interactive teach
7. or
* Start interactive entry
point teaching
:
■
or Start . The appliance
moves along the boundary cable.
■
or Set when the appliance
has reached the required start point. The
start point is stored.
8. or
Set entry point 1
if no
start point has been specified during the
teaching-in movement. If no start point has
been specified here, the start points are auto-
matically specified.
9. or
Entry point x: XXm
if
the last start point has been reached.
Manually specifying start points (01)
The first start point (01/X0) is pre-set and is 1 m
to right of the base station. Other start points can
be defined after this point:
■
Robolinho 700: up to three start points
(X1 – X3)
■
Robolinho 1200: up to six start points
(X1 – X6)
■
Robolinho 2000: up to nine start points
(X1 – X9)
When specifying the start points, heed the follow-
ing:
■
Do not set start points too far from the base
station or too close to one another (02/f).
■
Only use as many start points as necessary.
1. or
* Entry Point
2. or
* Point X1 at [020m]
Select one digit in sequence with or
and accept accordingly with .
3. or * Point X2 at [075m]
Select one digit in sequence with or
and respectively accept with .
4. If necessary, specify further start points.
5. Return to the main menu with .
7.5.3 Setting the mowing times
NOTE
There must be at least 30 min. between
programming the mowing times and the
mowing start. If not, the appliance only
starts at the next programmed mowing
time.
In the
Weekly Program
menu item, the days of
the week and time periods when the appliance
should mow are set. Adapt these settings to the
size of your garden if necessary. If unmown ar-
eas are still visible after approx. one week, in-
crease the mowing periods.