AL-KO SOLO 127429, Operating Instructions Manual

Page: 56 / 548

GB
56 6436 | 6442
Transport
Malfunction Cause Remedy
Only sawdust is thrown out,
rather than wood chips. The
chain saw has to be pushed
through the wood. The saw chain is blunt. Sharpen the saw chain or contact an
AL-KO service centre.
Device vibrates unusually. Device errors Contact an AL-KO service centre.
10 TRANSPORT
WARNING!
Danger of fatal injury and danger of
extremely severe injury.
During transport, a running saw chain
can lead to extremely serious and even
fatal injury.
■
Never carry and transport the chain
saw with the saw chain running.
■
Before transporting, carry out the
measures mentioned above.
Before transporting, carry out the following mea-
sures:
1. Switch off the engine.
2. Allow the device to cool down.
3. Remove all traces of saw chips or oil resi-
dues.
4. Pull the protective cover over the guide rail.
Only carry the chain saw using the handle. When
doing this, the guide rail points to the rear.
In vehicles: Secure the chain saw against tipping
over, damage and leakage of service products.
11 STORAGE
Thoroughly clean the appliance after each use
and – if present – attach all covers. Store the ap-
pliance in a dry, lockable place out of the reach of
children.
Carry out the following jobs before intervals in
work lasting for longer than 30 days:
1. Completely drain the fuel and oil.
2. Remove the saw chain and guide rail, clean it
and spray it with rust-proofing oil.
3. Thoroughly clean the device and store it in a
dry place.
IMPORTANT!
Danger of damage to the appliance
Dried-on/sticky saw chain oil can lead to
damage to oil-channelling components
after lengthy storage.
■
Remove the saw chain oil from the
appliance before an extended period
of storage.
12 DISPOSAL
■
Before disposing of the device you
must empty the fuel tank and the en-
gine oil tank!
■
Petrol and motor oil do not belong in
household waste or the public sewer
system, but should be collected and
disposed of separately.
Packaging, equipment and accessories are made
from recyclable materials, and must be disposed
of accordingly.
13 TECHNICAL DATA
Type 6436 6442
Item no. 127429 127430
Engine type 2-stroke 2-stroke
Engine displacement 35.2 cm³ 41.9 cm³
Maximum engine power in kW (according to ISO 7293) 1.45 1.7
Easy Start system Yes / primer Yes / primer
Idle speed 3000 ± 400 min
-1
3000 ± 400 min
-1
Maximum speed 12000 min
-1
12000 min
-1