AK-CA-38 - user manual
p. 3
Problem
Cause
Solution
The
components
connected
via power supply /
adapter does not work
adapter or computer
No mains voltage
ź
Check the correct connection of
the power supply to the power
network
ź
Check the mains fuses
The power adapter is
overloaded
ź
Disconnect the power adapter
from energy grid, check the
correctness of the current
parameters
Incorrect connection of
the device
ź
Make sure that the adapter is
correctly connected to the
computer components
ź
Check that the wires are well
embedded in the sockets
There is a suspicion of a
product defect
ź
Stop using and contact the
seller
The computer turns off
The adapter has
insufficient parameters
ź
Check if the power of the
adapter covers the demand of
the computer components
Removing the most common problems
PICO power adapter
1.
Connect the 24-pin adapter’s plug to 24-pin socket on mother board. Try not to touch the
electronic components or contacts on the adapter.
2.
Connect the P4 connector to the motherboard if it is required by CPU to stabilize the work.
3.
Connect the Molex plug to a hard disk, optical drive or fan with a corresponding Molex socket.
4.
Connect the SATA plug to a hard disk or optical drive with a corresponding SATA socket.
5.
In case the P4, Molex and Sata plug are not used, unplug it from the adapter.
6.
Then, take out the power cord of the housing, in a way that provides easy and safe access to
connect an external 12V power supply without opening the case.
Connecting the adapter to the computer components:
Cleaning the power supply:
ź
Use soft and antistatic cloth for cleaning the adapter.
ź
Do not use abrasive or chemical cleaners.
Disconect the adapter from the electrical socket and connected devices before cleaning.
