3
dx turntables
dx turntables
PART NAMES AND FUNCTIONS
1. START/STOP
9. TONE ARM
Press this button to start or stop the platter.
This is a fully manual tone arm. To start playback, gently place the
stylus on the record using the headshell finger support. Do not drop
2. PLATTER
the stylus onto the record as it may cause damage to the diamond
tip and to the record.
3. MOTOR OFF
Press the button to enable motor off, and the led will be flash .
10. 45 RPM ADAPTOR
Press the button again to disable function.
Place on center spindle for playing 7” records with large center holes.
4. TARGET LIGHT
11. ANTI SKATE KNOB
Insert target light to the deck and it will light up.
When a record is playing, a force is generated drawing the stylus
towards the center of the record. Set this knob to the same value as the
5. PLATTER REVOLUTION SPEEDS (rpm)
stylus pressure to offset this force.
33 rpm Press 33
45 rpm Press 45
12. COUNTERWEIGHT
78 rpm Press 33 and 45 buttons simultaneously. To return to 33 or
Use this to balance the tone arm and to adjust the stylus pressure.
45rpm play mode, just press the desired button.
13. POWER SWITCH
6. REVERSE
This switch turns the power on or off, including the motor and audio
This button is used to reverse the direction of the platter rotation.
signal
7. HEAD SHELL LOCKING NUT
14. POWER CORD CONNECTOR
Attach the headshell by inserting into the front end of the tone arm,
Used to connect the included power cord.
then turn the locking nut clockwise with the head shell firmly held
horizontally.
15. GND
Ground wire connection post
8. PITCH SLIDER
Use this to change the speed of the platter when the PITCH indicator
16. PHONO OUTPUT
is NOT lit.
This is the standard analog output (RCA jacks) which can be
connected to phono input on any DJ mixer.
1
1
4
5
6
9
8
7
2
3
16
15
14
13
e
ng
li
sh
12
11
10
