www.aja.com
50
Ki Pro Quad v5.2r3
Only one LUT may be loaded to the Ki Pro Quad at a time. This single LUT may be used for
either the input or output. If you do not wish to apply a LUT, simply don't select it with
the 13.3 LUT Enable parameter.
The Ki Pro Quad supports the import of .txt and the .lut extension files.
NOTE:
The 1D LUTs should be formatted with the following conditions:
1024 values (10-bit), 3-column tab delimited text file with either .txt or .lut file extensions.
32.0 Loss of Video
This parameter selects whether recording continues when valid video is not present.
These are the options:
NOTE:
If CONT Rec is selected, and a loss of video is encountered, a graphic with the text “LOSS OF
VIDEO” superimposed over color bars will appear. Be sure to check your source and video
connections if you are experiencing a loss of video.
41.1 VIDEO SG FRMT
This parameter determines the video format output from Ki Pro Quad’s internal test
signal generator. This parameter is used with parameter 41.2 to determine the type of
video test signal output by Ki Pro Quad.
NOTE:
While the Ki Pro Quad may be configured for a YCbCr or RGB signal generator, the output is
ultimately determined by the selection made in the 1.6 SDI OUT menu parameter.
Example:
The 41.1 VIDEO SG FRMT is set to 1080p 23.98 RGB and the 1.6 SDI OUT is set to SDI 1
RGB, then the output will be RGB. If the 41.1 VIDEO SG FRMT is set to 1080p 23.98 RGB
and the 1.6 SDI OUT is set to SDI 1 YCbCr, then the output will be YCbCr even though the
signal generator was configured for RGB.
Stop Rec (default)
Cont Rec
Recording stops when video is lost
Recording continues when video is lost
