HELO Plus H.264 Streaming and Recording Encoder v1.0 22 www.aja.com
• Encoder Status
• Scheduler Status
• Streaming Output
• Recording Output
Each group of parameters can be expanded or collapsed.
Some of the parameters are editable using a right click. For example, right clicking
on the Video Source selection will bring up a list of available inputs, allowing
you to change it. Parameters cannot be changed when currently streaming or
recording.
All available parameters are accessible by clicking on the Menu screens listed on
the left.
Config Screen
The Config Screen has several parameters for HELO Plus general operation.
Video Source
Selects a video input source from the available video input connections. This is
the video that will be recorded and/or passed through.
HDMI -
Use the HDMI input as the video source.
SDI -
Use the SDI input as the video source (factory default).
Test Pattern -
Use the internally generated test pattern as the video source.
Layout -
Use the currently active Layout.
The HELO Plus's SDI and HDMI video outputs will be synced to the SDI Video
signal input when the HELO Plus has SDI selected as its Video Source parameter,
or when the Video Source parameter is Layout and SDI Enable is On, and when
a valid SDI Video input signal is present and has been stable for more than two
seconds, and the SDI signal was valid and stable at the time recording/streaming
began and it has never dropped or changed format since. Under all other
circumstances the Sync generator will be in Free Run.
