Airzone innobus, User Manual

Page: 58 / 68

58
10.2. Presence Detector
If your installation is provided with volumetric
detectors connected to Innobus, the system will
operate normally when these detect presence in
the zone.
If the sensors detect no presence in the zone for
more than 5 minutes, the system will apply the
SLEEP mode to the zone and the relevant Tacto
thermostat will show the message PRES
(
PRES
).
When the sensors detect presence again,
Innobus will automatically return the zone to its previous condition.
10.3. Access to Remote Zones
You can control all the zones of your installation from any Tacto thermostat just by following
these steps:
1)
Press on the set point temperature area for a couple of
seconds. The thermostat will show the zone where you
are and immediately will show the first accessible zone.
2)
Using the arrows select the zone you want to access
and confirm it by pressing on the AIRZONE icon once.
The status of that zone will appear on the screen.
3)
Change the parameters you require and press on the
AIRZONE icon to confirm the changes. You can change
the following values:
•
On/Off status of the zone.
•
Set point temperature (with the remote zone in the
ON position).
•
Ventilation speed (where enabled).
•
Manual or Automatic Operation Mode.
•
Air-conditioning Mode (only with access to the
Master Thermostat).
•
Activate the Sleep Mode.
NOTE:
Remember that you can only modify the operation
mode by accessing the remote zone associated to
the Master Tacto thermostat.
If your installation is provided with speed control
(please check with your installer), once you confirm
the changes to the remote zone by pressing on the
Airzone icon once, the system will ask you to enter
the ventilation speed.
Fig. 18 – Active presence detector
Fig. 19 – Press down and hold to
access a remote zone
Fig. 20 – Information on the
present zone
Fig. 21 – Access to Remote zone
Fig. 22 – Changes to remote zone
1
Warning: no
presence is
detected