10
MODIFYING THE AIR BLOWING DIRECTION
The unit sizes 07 to 12 can be supplied configured for either frontal air blowing, known as "IN LINE", or for side air
blowing, known as "REAR". It is also possible to modify the air-blowing configuration on site. To achieve this:
1 - Remove the top panel
1
.
2 - Remove the fan motor access panel
2
and
release a small length of motor cable.
3 - Remove the fan blower panel
3
.
4- Fit the fan blower panel
3
in the same location
as the access panel
2
.
4 - Refit the fan access panel
2
.
5 - Refit the top panel
1
.
FILTER ACCESS
1
2
3
1
2
WITHOUT PLENUM
WITH PLENUM
The filter can be removed
ONLY
from the top without
having to dismantle the connection duct
The filter can be removed either from the side
1
or from
the top
2
without having to dismantle the connection
duct.
Summary of Contents for HRW 07
