Appendix B
l
Replacing the air filter
Airvana ipBTS C30 Installation and Commissioning, Release 4.0
B-5
Figure B-3.
Replacing a fan tray
Replacing the air filter
The air filter in the main filter rack is located at the bottom of the RN shelf. The filter should be
inspected frequently and either cleaned or replaced to maintain a positive cool air flow through
the RN shelf.
Tools required
To replace the air filter you will need the following tools:
•
#1 phillips-head screwdriver
To inspect and clean or replace the air filter refer to
as you follow this procedure:
Procedure
1. Grasp the air filter handle with your fingers and pull the filter straight out to remove it
from the metal channel holding it in place.
2. Inspect it for dirt and debris. Replace or clean the filter, as appropriate.
To replace the filter:
3. Insert a new filter so that the back seats securely in the channel in the back of the RN shelf.
Captive screw
Summary of Contents for ipBTS C30
