Airtug® /
/ 216-941-9781 / www.airtug.com
Step 1:
Install the handle all the way through the second “U”
bolt. Push the handle approximately 1-1/2” beyond the
second “U” bolt. If it appears the handle will not fit through the
“U” bolt, loosen the nuts below. This is a very close tolerance
so the bolt will not interfere with the caster wheel. Once the
handle is installed, tighten nuts securely.
Step 2:
The throttle cable and transmission cable are zip tied
to the engine. While holding each cable separately, cut the zip
tie and unravel each cable towards the rear of the tug. Attach
the throttle cable to the right side of the handle using the
fasteners already in the handle with a 5/16” socket.
Step 3:
Attach the transmission cable end to the left hand grip
with the “ball” on it. Then open the nuts located several inches
from the hand grip on the cable and slip the cable between
the bracket on the left side of the handle and then secure the
nuts firmly using an 11/16” wrench.
Note:
Using the zip ties provided, secure
both cables to the handle towards the bottom of the handle
loosely.
3
