Airtec Expert CYPRES 2, User Manual

Page: 52 / 74

- CYPRES 2 User’s Guide - page 51
12. Switching rigs
Switching your CYPRES 2 to another
CYPRES 2-ready rig will require only a few mo-
ments of work for your rigger.
If the container swap requires a change in the
number of release units (cutters), this can be done
quickly on-site by unplugging the old cutter and
swapping it with the required cutter type (1-pin or
2-pin). It is not necessary to send the CYPRES 2
to the manufacturer. The required cutter can be
purchased from your CYPRES dealer.
11. Abbreviated User guide
Switch CYPRES on only when you are
at the dropzone on the ground !
When airfield and dropzone are at the same
place, always switch CYPRES off and back on
again when:
• CYPRES arrives at the dropzone by any
means other than under an open canopy (e.g.,
by car, or by walking back from landing
away from the dropzone.)
• total flight time (leaving the ground until back
to the ground) was longer than 1.5 hours.
If airfield and dropzone are at different locations:
• Before every jump, switch CYPRES off
and then back on at the airfield where your
aircraft takes off from, and change the drop -
zone offset as appropriate.
General recommendation: If in doubt, reset CYPRES
by switching it off and on again.