Airtec Expert CYPRES 2, User Manual

Page: 34 / 74

- CYPRES 2 User’s Guide - page 33
100 ft. activation altitude increase (left digit blinks)
dropzone offset 120 ft. up
4.4.4 User selectable activation altitude
& dropzone offset feature combined
The User-Selectable Activation Altitude feature
(Sections 4.4.2 & 4.4.3 and the Dropzone Offset
feature (Section 4.4.1) can be used independently
or in combination. When used in combination,
the selected Activation Altitude Setting number
blinks on the very left location of the display, and
the Dropzone Offset (up to ±3000 ft. or ±1000
meters; up to ± 1050 ft. or ± 350 meters for WSC
) is shown on the right side of the display when
CYPRES is on.
4.4.5 Changing the scale
If your CYPRES 2 Dropzone Offset scale is set in
meters and you want feet or vice-versa, you must
enter the unit information area by pressing the
button down immediately when the has
appeared at the end of the self-test, and then keep
it pressed down (see User guide Section 4.5). After
your CYPRES 2 has shown the flight counter, the
serial number, the next possible maintenance date,
it shows the feet or meter setting*.
• Just release the button ½ second after the cur -
rent feet or meter setting is displayed,
• immediately press it again,
• release it when the LED turns off,
• then click on your choice of feet or meter and
CYPRES will shut down.
This procedure only needs to be done one time.
(Note: For units produced or updated after 01/2013
this procedure replaces the one described in the
last paragraph of User guide Section 4.4 edition
1/2012 and earlier.)
*Feet or meter selection option not available on
CYPRES 2 manufactured prior to August 2005.