37
5.13
AHU
•
Position the nozzle rack in safe distance from “non wet area“ to avoid turbulence causing water outside the humidification chamber.
•
Start by lining the nozzle up as illustrated in the order confirmation. adjustment can be done during startup commissioning if needed.
•
Ensure that the both rack and nozzles can be maintained through inspection door in a safe way.
•
Position the duct sensor in safe distance after the wet chamber. Considerinig air velocity, there can be super fine water aerosols that
may cause sensor mis readings.
•
Room sensor should be position in exhaust air.
•
Position the bulkhead behind the rack, to avoid hoses in front of the nozzles.
Min. 20 m
m
A
- Bulkhead
B
- Foot
Inspection door
- Not incl.
Light
- Not incl.
Seperator
Droplet seperator
- Option
Seperator restraints
- Not incl.
Blanking plate
- Not incl.
Seperator restraints
- Not incl.
Seperator support channel
- Not incl.
Drainer
- Not incl.
Seperator fixing angle
- Not incl.
Recome
nded
500 - 10
00 mm
at 1 - 3 m
/s
Inspection door
- Not incl.
C
- End nozzle
D
- Water inlet
E
- Nozzle bracket S
F
- Rack bracket S
Air flow
Top
A
C
B
D
E
F
201218
