maintenance
8-14
Flying Cloud
Lubricating Rotating Gear Housing
In the event that rotating the antenna becomes difficult,
lubricating the bearing surface between the rotating
gear housing and the base plate can restore normal
operation. Any spray-type silicone lubricant may be
used.
1
Gear (Lubrication Point)
2
Setscrew
3
Base Plate (Lubrication Point)
Elevate antenna and remove setscrew from rotating
gear housing as shown. Spray lubricant into hole and
around edges of gear housing. Rotate gear housing
until lubricant coats bearing surfaces and antenna
rotates freely.
Water Pump
Water Pump Access Locations
The 19 ft. model has the water pump located under
the roadside front dinette seat. Access is gained by
removing the wood panel under the seat cushion.
The 20 ft. model has the water pump located under
the galley. Remove the drawer under the cook top for
access.
The 23 ft. model has the lower front face panel on the
roadside wardrobe hinged to open and expose the
pump and filter.
The 23 ft. Front Bed model has a removable lower
front face panel on the roadside wardrobe held on
with a pressure catch and the lower wardrobe shelf is
removable to access the pump and filter.
The 25 ft., 27 ft., and 30 ft. water pump location is
under the roadside wardrobe. The bottom cabinet
panel is held on with a pressure catch and pulls off for
access.
The 28 ft. water pump location is under the refrigerator.
The bottom cabinet panel pulls off for access.
The 30 ft. Bunk water pump location is behind the
panel below the pantry
Strainer Cleaning
1
Pump
2
Housing Cap
3 Strainer
Locate the water pump and housing cap. Turn housing
cap counterclockwise to remove cap and carefully pull
out strainer. Clean strainer in small bucket of clean
water or under running water. If necessary, clean
strainer in a detergent solution. Install strainer and
housing cap, being careful not to damage housing cap
seal.
Fresh Water tanks and Draining
Drain Valves
Under the trailer are galvanized steel boxes that are a
few inches lower than the trailer frame. These boxes
are insulated exterior tank pans and they support the
freshwater and holding tanks. Petcocks open with a 1/4
turn, line drain valves are open when the widest part of
the oval valve handle aligns with the water line.
Drain Valve Locations
The 19 ft. Bambi low-point water line drain valves are
located in two different places. Two are located under
the rear bed and access has been provided in the bed
top under the mattress. (If you are long and lanky, you
may be able to reach them through the exterior storage
compartment.) The other two line drain valves are
located under the roadside dinette seat. The water tank
drain valve is also located under the same roadside
dinette seat.
Summary of Contents for 2015 Flying Cloud
