Airstream 2015 Flying Cloud, Owner'S Manual

Page: 53 / 116

5
Interior
Flying Cloud 5-19
Sender panels are installed and stuck to the sides
of the holding tank Sender panels can be cut to
match the height of the tank, it also auto calibrates
itself so it can read from empty to full The sender
scans the water level through the tank wall using
digital techniques programmed into the sender
microprocessor
To Read a Water or Sewer Tank Level
1 Press the button corresponding to the tank to be
checked and release it, the display will show the
levels in percent on the led display If no other
button is pressed, then the display shuts off after
about 5 seconds
2 If another button (including BaT) is pressed before
the 5 second time is up for the first button, the
display will immediately switch to show the new
level or voltage The 5 second time-out is restarted
every time a button is pressed
3 To continuously display a reading, press and
release the desired button, and then press the
same button a second time When the button is
released, the display will be on hold mode, which
is indicated by the decimal point on the right hand
side turning on While the display is in the hold
mode it will recheck the level once per second
so the user can watch the level change while the
tank is being filled or drained. The display will
automatically shut off after 5 minutes in hold mode
To end the hold mode before the 5 minutes is up,
press any tank button, and the display will shut off
To Read the Battery Voltage
1 Press the BaT button and release it, the display will
show the battery voltage on the led display
2 If no other button is pressed, then the display will
shut down after about 5 seconds If the BaTTeRY
button is held down, the display will continuously
recheck the voltage and show the updated value
The reading may flicker back and forth between
two values
3 If another button is pressed before the 5 second
time is up for the BaTTeRY button, the display will
immediately switch to show the value for the new
button The 5 second time-out is restarted every
time a button is pressed
4 There is no hold mode for the battery voltage
To Program the LED Brightness
1 The display needs to enter the brightness
programming mode To do this, press and hold
the BaTT button; the display will show the battery
voltage
2 While continuing to hold the BaTT button, press
and hold the gReY button Continue to hold
both buttons for approximately 5 seconds until
the display show “bri“ to indicate the brightness
programming mode When this occurs, release
both buttons
3 Press the gReY tank button to increase
brightness, or the FReSH tank button to decrease
brightness
4 When the display shows correct brightness, press
the BaTT button to exit the programming mode