18-07-2022 / A-00222-A
6
MAINTENANCE
LED MODULE
⇒
It is important to replace any damaged led module.
⇒
The replacement of a led module has to be done in the AIRSTAR network, please contact your AIRSTAR reseller.
ENVELOPE
⇒
A damaged envelope must immediately be repaired or replaced.
⇒
Regularly clean the envelope with mild soap and water. Citrus-based cleaners can be used, although be sure to test a small area
before cleaning entire envelope.
How to change an envelope
Remove the old envelope
⇒
Open the zipper
⇒
Unscrew the nut on top of the envelope
⇒
Remove the envelope from the bottom to the top
Install a new envelope
⇒
Place the new envelope from top to bottom
⇒
Loosely screw the nut on top of the envelope
⇒
Close the zipper
⇒
Tighten the nut on top of the envelope
Patching A Hole
⇒
Make sure to thoroughly clean the area to be patched.
⇒
Cut a square out of the included self-adhesive fabric sheet just large enough to cover the damaged part of the envelope.
⇒
Remove the protective film from the adhesive side of the patch material.
⇒
Carefully place the patch onto the damaged part of the envelope, inside and outside the envelope.
⇒
Firmly applying pressure to the areas of contact around the patch edge.
CLEANING THE AIR FILTER
⇒
Under the south pole plate, remove the rain cover protection and its 3 screws.
⇒
Remove sponge-type air filter by sliding it along the support stand.
⇒
Wash it or replace it.
⇒
Put back the clean air filter.
⇒
Put back the rain cover protection and its 3 screws.
REPAIR KIT
