18-07-2022 / A-00222-A
5
INSTALLING YOUR SIROCCO ON A STAND
Make sure there is sufficient space in the installation area to allow the balloon to be inflated and to prevent the product from
tipping over when inflating.
NOTE:
•
Always use AIRSTAR-approved stands designed to work with your Sirocco unit.
•
Always securely tighten all T-Handles to avoid injury.
•
Stands are designed for vertical mounting of Sirocco units ONLY.
⇒
Unfold the stand.
⇒
Lock the base in place.
⇒
On the optional stand P500AH (Fig. 4), lift the outer cylinder at the base slightly, then hook the oval locking ring over the safety
hook.
⇒
On the optional stand P500TA, slide the stand legs out from the folded position until the support bars are exactly horizontal.
⇒
On the P500AH (Fig. 4), weights must be placed on each foot at 24 in (60 cm) from the center of the stand.
⇒
On the P500TA (Fig. 5), weights must be placed on each support at 20 in (50 cm) from the center of the stand.
⇒
Follow this correlation table (indicative for a flat floor and a steady wind)
⇒
Guy ropes are the only way to ensure the safety of the light stand in strong or gusty wind.
⇒
In the case of an uneven surface or sloping ground, the stand column must remain vertical and the tripod legs must rest on a
solid surface.
Wind speed
Recommandation
0 to 31 mph (0 to 50 km/h)
79 lbs (3 x 26.5 lbs)
31 to 43 mph (50 to 70 km/h)
159 lbs (6 x 26.5 lbs) OR guy ropes
43 to 62 mph (70 to 100 km/h) 159 lbs (6 x 26.5 lbs) AND guy ropes
20 in
(50 cm)
Load
Load
Load
24 in
(60 cm)
Load
Load
Load
Fig. 4
Fig. 5
