M an ag ing Freq u en cy Tab l es
C o m m i ssi o n i n g M an u al
20.2.5. Task 4: Specify Operating Frequency Table ID
After you add the frequency table to BSR and SPRs/IDRs, you need to instruct the
devices to use this specific frequency table. This is performed at the BSR.
To specify the operating frequency table ID:
In the BSR Zoom window, from the Configuration menu, point to
RF
, and then
choose
Hopping Configuration
. The Hopping Configuration dialog box
appears.
1.
Figure
20-10: Entering frequency table ID number
2.
3.
In the
Frequency Table ID
field, enter (as shown in the figure above) the
frequency table ID that you added to the BSR and SPRs (i.e. ID #32).
Click
Apply
. The following message box appears.
Figure
20-11: Message box informing to reset device for changes to take affect
4. Click
OK
, and then click
Close
to close the Hopping Configuration dialog box.
20-18
Airspan Networks Inc.
01040311-07
