605-0000-703 EasyST 49 Installation User Guide-Rev D
16
First left-most
LED is on
5 < = SNR < 9
Two left-most
LEDs are on
9 < = SNR < 12
Three left-most
LEDs are on
12 < = SNR < 16
Four left-most
LEDs are on
16 < = SNR < 22
Five LEDs are
on
22 < =SNR
PRO mode
Customer mode Off
Red
Professional
Mode #1
On
Modulation and FEC
Green
Professional
Mode #2
On
RSSI
signal
N/A
Professional
Mode #3
N/A
N/A
LED Button
The LED button (planned for the future) located below the LED lights provides the following
functionality:
Toggles between LED modes:
Each time you press the button, the LED mode changes:
o
Customer
(standard mode):
Signal
LEDs display SNR value as described in the table
above
o
Professional #1:
provides technician with indication of RSSI
o
Professional #2:
provides technician with an indication of the modulation and FEC used in
the uplink (planned for future release)
o
Professional #3:
provides technician with indication of downlink throughput (planned for
future release)
Resets EasyST to factory default settings:
To reset to default settings, hold down the
button for 10 seconds
Note:
When any of the Professional modes are continually active for 30 seconds, the mode
returns automatically to the Customer mode.
